I have a problem, I need the curve to be mirrored but follow the direction of the original copy, I don’t know how to place the plane so that it can be the original direction.
MPR.3dm (103.1 KB)
MPRD v9.gh (477.3 KB)
MPR.3dm (103.1 KB)
MPRD v9.gh (477.3 KB)
I assume it’s because of the orientation of the plane, however I don’t know how to set it so that the projection of the copies follows the same direction.
I have a problem, I need the curve to be mirrored but follow the direction of the original copy, I don’t know how to place the plane so that it can be the original direction.
I think it’s because of the orientation of the plane that is in x but it should be the same as the scissor system in Z, but I don’t know how to place it, please help
MPR.3dm (103.1 KB)
MPRD v9.gh (478.1 KB)
I tried to understand your question. But please help us first, so we might be able to help you:
- Excuse me if I see so: Your canvas is “spaghetti” → very hard to see what and why stuff is connected. Keep it clean, so you can always find your way easily back
- couple of plugins, not on my system. And do not want to install them. So best is to not included plugin component (unless it is a question about the plugin)
Best is to isolate your issue. Take the couple of curves + planes what you want us to look at. Place GEO, POINT, etc components, internalise the data. And just copy that little part to a new *.gh file. No need to send your 3dm file too
Regards, Eef
