Modify Dome Slicer to Slice cylinder?

[kev.r (Kevin)]

Using the code I posted at the bottom of the thread you referenced above:

Slicing Dome, creates offset with duplicate data, What am I missing?

Came up with this after some googling and experimenting: [221005_gcode_02] [221005_gcode_01] Slice Test_kr2.gh (107.5 KB) It seems that the G03 command starts the arc at current position and ends at the point (X, Y, Z points) you supply (look at your previous attempts, the first arc is drawn from the 0,0,0 position to the first coordinate you supplied). You need to supply some move commands (G0) and it seems more reliable to make the circles in 2 segments. Move → First Half Of Circle → Se…

Your geometry produces errors with the Deconstruct Arc component. I re-built your cylinder and it works without errors (only change to gh file I referenced above is new input geometry).

Slice Test_kr2_230517.gh (61.1 KB)

Output from your simulator looks ok to me.

-Kevin