Metaball fewer lines

[laurent_delrieu]

hello
you already poster there

Metaball want to add a point attractor or curve attractor?

Hello, I’m trying to combine two script to create one but I don’t know how exactly since the metaball that I’m using is 2d and I tried extrusion with the z factor. It only goes in one direction and I’m trying to have multiple points or curves. Do I need to bake the metaball curve and then do a curve attractor to it? 3.3.2024.3dm (2.7 MB) metaball with point attractor_curve attractor.gh (3.2 KB) [image]

and there

Metaball with curve attractor or point attractor

Hello, I’m trying to combine two script to create one but I don’t know how exactly since the metaball that I’m using is 2d and I tried extrusion with the z factor. It only goes in one direction and I’m trying to have multiple points or curves. Do I need to bake the metaball curve and then do a curve attractor to it? 3.3.2024.3dm (2.7 MB) metaball with point attractor_curve attractor.gh (3.2 KB)

I am not sure you uderstand what you are doing or you doesn’t explain it very well.

Is is intended you put your point population in the isocurve component ?
Most of the time you just input a point.
Why are you using an accuracy so high ? I hope it is just for the calculation time. if not why using Metaballs to have a jagged result!
Metaball(t) could be more useful

You can use a range component

Multiple planes could also be more nice if you intend 3d.

…