Merge the edge frames into one and also have thickness

[Deep1 (Deep)]

Grasshopper Facade 02.gh (16.8 KB)

Hey guys,

I am attempting to wrap staggered quad panels around the four sides of the facade, creating seamless panel conditions on the edges while also adding thickness to the frame. Unfortunately, I couldn’t. Anyone have any suggestions or ideas for dealing with this? I searched the forum for similar topics, but there are not any.

Thanks in advance.

[Gijs_Jonkheer]

It is not completely clear to me what you are after. Can you elaborate? Maybe model a section up in rhino?

[René_Corella]

There are a few things you could do with the per-brep/srf data structure, but something quick that could work is this:
Grasshopper Facade 02.gh (32.6 KB)

[Deep1 (Deep)]

Thanks for the responses. So acutally I am trying to have a seamless edge condition similar to one shown below rather than breaks.

[Deep1 (Deep)]

Thanks for the response. I should have been much more clear. I have included a reference image in the post below if that helps in what i am looking for.

[rajeev_pulari]

may this is what u r looking for

Grasshopper Facade 02_rev1.gh (23.2 KB)