Hello everyone, I am trying to make a relation where when the line has fully reached its maximum size, the spiral is almost none, but when the line is getting smaller, the spiral would be increasing its size and the number of turns. I could define the spiral and the size for being capable of handli…

I don’t know what to do. However, dividing by distance does not allow me to make a precise calculation. R min is 0.007, circumference 0.044, and the rectangle is 0.011 long so there can be a maximum of four rectangles in the first 360°. To find the Domain start I set the slider to zero and then s…

I see nothing in the GH code that resembles the videos :question:

Sorry, but I don’t get it. The videos are resumed to me sliding the number slider (0.000 to 1) conected to multiplication component before the construct domain. Maybe is because the offset curve component is with negative component connected to “distance”?

I used to be active on this forum but have cut way back in recent months because of poor descriptions and poor reasoning in GH…

Sorry I don’t have your level or capacity in grasshopper, that is why I am asking here. I think what I had asked was understandable, but feel free to show me where it isn’t clear.

[image] Leo: feel free to show me where it isn’t clear. I already did .

[image] Joseph_Oster: I see nothing in the GH code that resembles the videos I still cannot understand what you have questioned. Sorry. The videos clearly are made from the script.

[image] Leo: The videos clearly are made from the script. I don’t know how to sat it more clearly. [image] Joseph_Oster: I see nothing in the GH code that resembles the videos :question:

man, you can say that nothing in the code resembles what I described as my goals, but not the video, since the videos were made from the script.

You might need to zoom in a bit…

Maybe oyu can draw the result in Rhino so it’s easier to understand…

Spiral to line

Grasshopper

Joseph_Oster December 26, 2025, 4:34pm 2

I see nothing in the GH code that resembles the videos

Topic		Replies	Views
How to Create a Spiral in the Middle of a Curve Grasshopper windows	11	401	February 16, 2026
Control spiral by the distance between two laps Grasshopper windows	13	262	February 12, 2025
Spiral from point to point with non constant slope Grasshopper mac	22	1892	September 6, 2021
Spiral tool for grasshopper Grasshopper	36	24972	August 21, 2023
Curve along irregular geometry Grasshopper	12	1823	June 16, 2024

Spiral to line

Related topics