What about that video of Autodesk promoting itself that shows a monitor with Rhino open and they didnt even knowledge the use of Rhino in the video description?
I posted a screen cap in this thread
and this is timed on another moment of the video that they show Rhino on the recording
I actually like to do the fillets manually to have better control on the composite parts, but yes, we wouldn’t do it in Rhino because the Solidworks curvature analysis to check the radius wouldn’t pick up the radius value, and in our workflow we needed the screen cap from the solidworks tool to add to the checklist to collect the signatures needed to send the parts to fabrication, since solidworks was the “official modelling tool”.
In the end, complex filleting points, where multiple edges arrived, we would usually need to get back to rhino to finish it, because solidworks would fail or produce ugly results.