Hi there, i’m trying to create a spline tangent to the hull and struggle to collect the points free in space. Instead two curves are created by the one Interpolate modilue. I have marked the points to collect for the curve in red circles below. Thanks… [Nurbs curve - point collection failure]

Yeah, I was just looking at your yacht merge component.gh file and can see the problem, without yet fully grasping the intent… The problem is that Merge can mix up the sequence of inputs (points in this case) due to data trees. You can replace it with Entwine and flatten the output: [Yacht_2022O…

Points for curve

Grasshopper

BauerNaval (André Bauer) October 26, 2022, 1:41pm 6

I have isolated the components, internalised the data and wrote a description in a panel.
Could you have a look again?
merge component.gh (31.1 KB)

Topic		Replies	Views
Cannot connect points to make curve line Grasshopper windows	5	328	September 12, 2023
Issue Interpolate curve Grasshopper	9	3161	January 9, 2020
Sinc three lists to interpolate curve Grasshopper	2	399	November 11, 2020
Curve through points Grasshopper windows , rhino7	5	10887	February 12, 2025
Struggling with interpolating points Grasshopper Developer windows	3	291	May 15, 2023

Points for curve

Related topics