Nesting laser cut lay out

[intrinsic5 (airoaya)]

Thanks tim
i checked topic

The last definition seems to work in my work

But I found that the vertical member of the two breps did not work properly with debrep. Maybe there is a wrong section. I’ll check.

And I hope the array is done in a square frame like the one I posted before

1 - re.gh (109.3 KB)

and i use contour at vertical one for waffle rib

Grasshopper 3d frame waffle laser cut

hi, i’d like to laser cut the brep in waffle frame i made waffle definition but it does not seem to work completely [9][10] This is probably due to debreped data is not aligned [14] [11] [12] [13] And another problem is that there are no overlap points when the slope becomes gentle. So can not divide brep in the same way I would appreciate if anyone could solve the problem. 0614 laser forum.gh (125.7 KB)