MoveUVN does not work on Rhinoceros 7 for Mac

[Said_Dogan]

Hi there.
I need to use “MoveUVN” command for offsetting curves. (Other offset commands did not handle the job for me).
The “MoveUVN” command doesn’t work at all. I run it again and again, but nothing happens.
I saw an entry from April that says the command didn’t come to Mac, but when I saw it in the interface, I thought it is working now.

I am open for any help and suggestions.

Thanks in advance!

[dan]

I can’t reproduce this issue in Rhino 7 for Mac. MoveUVN is working fine here when I select control points on a curve and move the U slider in the Move UVN Panel. If you’re still experiencing this, please provide more information so we can see this problem on machines.