Kinetic tape panels

Hello! Tell me, please, how would it be better to model kinetic panels on facades as in this project?

If through the SubD geometry, then using multipipe or how? The question is quite simple and versatile, but the tubular frame may not always look flat and rolled out in the panel-the tubes are inherently cylindrical. Understand correctly that I would just like to add such extended panel tapes in the project, but I do not quite understand what is the best way to model them-perhaps this can be done faster through Grasshopper (then how)?

this could be done in SubD or with a traditional 2 rail sweep and guide curves.

And if that’s the case you could for then also do the same in grasshopper.

1 Like