Things that would be nice to see: Option on FAIR to preserve the orientation of the ends. Currently, if a curve is tangent to other curves at the end, FAIR, makes them untanget. Option on CURVETHROUGHPT to specify start and end tangent curves. Option on CURVETHROUGHPT (Interpolated) to specify a …

:+1: I would love to see some kind of constraints for both curve and surface (Nurbs) editing: (all with the aim of “designing” curves and surfaces) symmetrie / reflect / radiate constraint G0,G1,G2 to curve end and surface edge (like mentioned above) lock single controll points set maximum and m…

[image] Miano: Option on CURVETHROUGHPT to specify a tolerance for control point curves such that the curve will be within the tolerance of the control points. Is this request is for CurveThroughPt with CurveType=ControlPoint? That option results in a non-rational degree 3 NURBS curve with u…

[image] Miano: Option on FAIR to preserve the orientation of the ends. Currently, if a curve is tangent to other curves at the end, FAIR, makes them untanget. Option on CURVETHROUGHPT to specify start and end tangent curves. I would also like these options to be implemented.

i had the feeling that this was requested a couple of times already, i found no topic on the quick run, i would also think that fair should preserve the orientation… assuming smooth works similar which you can use on single cp´s you could simply avoid the cp´s responsible for the orientation/tangen…

[image] Miano: Option on FAIR to preserve the orientation of the ends RH-72060 Fair: keep end tangents / curvature option as for your other wishes on CurveThroughPt, I’d like to see an example where this would be useful and how you would use it to better understand.

Attached is an example. The points are rounded to the nearest 1/16" in X/Y/Z. The should then be within 1/32" the location of the original curve. However, there can be errors. Problem Curve.3dm.zip (39.2 KB) I have drawn a curve using control points and done selvolumepipe 1/32. For most of the sec…

Feature Requests: Curves

Rhino Rhino for Mac

will (Will Pearson) December 22, 2022, 6:10pm 8

RH-72060 is fixed in the latest WIP

Topic		Replies	Views
Feature Request: FAIR and Tangency Rhino for Mac	1	284	June 8, 2021
Curve Through Point with Tolerance Rhino for Mac	8	644	June 29, 2020
Feature Request: InterpCrv Rhino for Mac mac	2	174	November 17, 2023
Set Curve Tangent Rhino for Mac	22	7646	August 12, 2020
How to make a continuous curve Rhino for Mac	15	4972	December 23, 2017

Feature Requests: Curves

Related topics