I am trying to create a zollinger pattern in grasshopper. I started with a grid of rectangles and connected the corners. Then I placed the same rectangles in the center of the lines and connected the corners aswell. My problem is that the line does not end exactly on the other, or just at one speci…

Zollinger Pattern

anon39580149 November 27, 2019, 2:18pm 2

Zollinger pattern with paneling tools PanelingTools

Anyone have any suggestions on how how to populate a surface with lamels like this using paneling tools? Note the offset of the diamond which creates some headache for me. Grasshopper is ok as well if not doable with paneling tools I have drawn the panel and the shape of the surface (which is just an extruded arc, so its not double curved) Any suggestions welcome that can point me in the right direction. [220px-Zollerbau07c] [zollinger-810x541] [11_Regensburg_Marina-Forum-07-%C2%A9-Hendrik-…

show post in topic

Home
Categories
FAQ/Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled