Hello,
this is my first time asking a question in the forum. I typically linger in the shadows, looking until i find something helpful. i have been making round speaker perf for exhibits manually for some time now and would like to set up a grasshopper file to save me some time. i also figure this is a good beginner project for me. i have attached a photo of the perf pattern that i produce a lot of. i am trying to build a file that will make this a bit automated and more dynamic. how i typically draw this in rhino is to draw my base circle ( the center pint of the perf), then i array that circle into a row. once i have that, i select each circle from the linear array, and i polar array that around the center circle. i was able to get to the linear array part in grasshopper, but i am struggling with how to handle the list of geometry the linear array spits out. i need to be able to take each circle from the linear array and polar array it with a unique number. each circle in the liner array from center get 6 added from the previous polar array. i think I’m struggling to articulate this. it’s quite simple. i am hoping the photo of the perf pattern speaks more clearly than i do.
if someone could give me a tip on how to take this to the next phase (polar arraying each circle).
thank you so much to whoever helps!!!
Concentric_Polar_Array.gh (8.1 KB)
