I am attempting to create a contours from a mesh imported into grasshopper through a geotiff and have been following instructions in a guidebook. So far it is going well, but I cannot get past this error message when I try to connect my u count to surface from points, “The UCount value is not valid for this amount of points.” I can’t figure it out. I’ve uploaded the grasshopper file here with where I am at. Please let me know if you can help.
Piggy backing off of this thread - I had a surface I was manipulating after converting to a mesh, and I was trying to achieve the same result with a surface by dividing/recombining and despite having 51 branches of points from a divide U count of 50, having 50+1 in the surface from points is still giving the The UCount value is not valid error and not working.