Twisted box through surfaces

Hi,

I had to use entertwine for this script and I dont understand why my twisted box through surfaces command is red even after I flattened the resulting loft surfaces.

Any suggestions as to why this is happening?

For more clarification, I have two sets of 3 curves set to each Curve command

Twist box throuhg surfaces_3006_Tai.gh (6.9 KB)

Thank you

Natalie Tai

Hi Natalie - without an actual gh file it’s always harder for someone to help you…
I think this one will work if you remove the {0;2} branch from the Entwine component.
-wim

1 Like

Would you mind editing the topic and changing it to the Grasshopper Pufferfish category.

Sure no problem Michael!

1 Like