Trimming the curves

Hi everyone,

I’m new at grasshopper, , I’m on a tutorial based on shipbuilding framing process. After framing the surfaces , i could not figure it out how to trim the curves at specified point and make them planar surfaces. there were many tutorial videos about splitting curves but there were defined cutting objects. It does not help for my framing process. It may come to you quite an easy question but any hint would be much appreciated.

Hmm I forgot whre’s the split curve by curve, if it exists :smiley:

this is a long method, i hope it help

surfaces.gh (8.5 KB)

there is another way by create polyline between the intersection points than explode and project to the surfaces
the problem is to find the best way to reorder the points and the surfaces

surfaces2.gh (10.9 KB)