Sweep Rail and Rotate Problem


#1

So I am sweep 2 railing my outside surface with 2 circles that have the same center point. I then have a curve (a bracket that I would like to attach to that surface) that I am rotating along that same center point but as I go down the profile it starts to deviate from the original surface?

Is there any way to have these match up?Sweep Rotate Problem.3dm (1.2 MB)


#2

The “circles” around which you are sweeping actually appear to be ellipses… Maybe you stretched them accidentally with gumball or something?

In any case, I would use Revolve and not Sweep2 to make your polysurface - more accurate, cleaner and guaranteed to be round… :smile:

–Mitch