Sweep 1 issue

[gorles_82 (GorLes)]

Hi,

I would like to create a sweep from vertical profiles an a rail, which is not touching the profiles and profiles dont start and end at rail endpoints. Sweep 1 in rhino works that way, as is shown in 3dm file (surface is created from green rail and profiles). However, in GH it was working this way a few updates ago, but not anymore. Now the surface starts at endpoints of the rail curve. On the other hand, if I offset the rail curve and use sweep 2, it works. Any tips?

sweep 1.3dm (233.3 KB)

sweep 1.gh (8.0 KB)

[Eef_Weenink]

same error?

Bug in the Sweep1 Component in Grasshopper since the last Rhino8 update

Can you post an example file which works correctly in 8.24 but fails in version >= 8.25?

[gorles_82 (GorLes)]

Yes, it’s the same issue that was decribed by Abel GROENEWOLT. Sorry, I didn’t see that post…

[jessesn (Jessesn Chen)]

@gorles_82

I would like to create a sweep from vertical profiles an a rail, which is not touching the profiles and profiles dont start and end at rail endpoints. Sweep 1 in rhino works that way, as is shown in 3dm file (surface is created from green rail and profiles). However, in GH it was working this way a few updates ago, but not anymore. Now the surface starts at endpoints of the rail curve. On the other hand, if I offset the rail curve and use sweep 2, it works. Any tips?

Thank you for your report, I’m seeing this issue as well. I have logged this issue with our development engineers.

RH-91044 Sweep1: the sweep surface is not touching the profiles and profiles dont start and end at rail endpoints