Hello
it could be possible but it could be better if you give more information on the “complex shape”
Are the curves parallel ?
is there a tolerance ?
A min rectangle size ?
What to do with parts not transformed to rectangle ?
Post some files …
and look at theses link
Hì everyone,
I would like to subdivide some non-convex surfaces into the minimum number of smaller rectangles that compose them. Kindly see the attached image where I have highlighted how I need to divide these surfaces. Is there any component or method I could do that? I have tried to see some old threads in the forum, but I couldn’t solve my problem.
Thank you so much in advance!
Carlo
[Non-convex]
Non-convex surfaces.gh (29.0 KB)
Hello!
I hope somebody can guide me in the correct direction with the following problem -
I have a surface.
[image]
It needs to be divided into smaller rectangles, where main criteria - smaller rectangles are as large as possible along horizontal lines.
Idea is that this surface is area of three layer precast wall. And I’m trying to find areas where I need to insert vertical ties through insulation layer.
With these rectangles I’d find what kinda length is necessary for the ties.
Problem…
Hi,
I would like to divide uneven surface based on corners/edges. Kindly see attached surface where I need to divide A to look like B. Would be great if it can be achieved with grasshopper. Is there any component or method I could do that. Tried using extend curve and heteroptera but gets weird with intersections in middle.
[surface-partition]
surface-partition.dwg (15.5 KB)