Please see the attached surface. Any idea how to rebuild the surface (keeping it a single surface) but with less crowded isocurve spacing around the arch area?
Thanks,
Sam
Please see the attached surface. Any idea how to rebuild the surface (keeping it a single surface) but with less crowded isocurve spacing around the arch area?
Thanks,
Sam
Hi Sam - I’d say you’ll need to create input curves that do not slide forward so much along that area-
-Pascal
Got it, I was trying to get too fancy, I was creating contour curves (horizontal sections), dividing them all by an equal number of points, interpolating the surfacing curves through these and pulling them to the surface etc… My question was poorly worded, but you helped,
Thanks,
Sam