Set default surface isocurves (to "off")


#1

Be nice to have the default surface isocurve “preference” in MacRhino…

–Mitch


#2

Mitch,

I agree, even though I rarely turn them off. There are preferences like this that should be set in a Preference / Options dialogue that stay on or off if checked or unchecked.

I typically set my grid snaps to 0.25mm instead of the default 1.0mm. I have to change this on all new documents. Would be nice to only have to set this once, like in 2010 and then not worry about it again, unless I need it changed.

Probably quite a few of these little hidden choice boxes that could be added to a ‘preferences’ box. Defiantly not one that has anything resembling a gear wheel !

Randy