I tried searching the forum, but couldn’t find this…
I am trying to decide which Rhino curves are not used by GH and can therefore be deleted. Can I use a command like SelGrasshopper or something, to select any objects that have been “set” to a GH component?
I was also wondering about that.
You could save before; note the duplicates and exit without saving.
I don’t remember now - and not in front of a PC - but I thought it was possible to zoom to select in GH.
Thanks, Wim! This is interesting, and certainly helpful. What I would really like to see is a Selection tool, rather than a Zoom tool. That way I could quickly Select all GH objects, run the command, and then InvHide inside Rhino. Or ZoomSelected to emulate this existing command.