Rotate and scale geometry based on proximity to curve

Grasshopper
5

Two significant changes:

  1. Fixed an issue that caused some buildings to “face” their short side to the boundary instead of their long side. Needed to connect “base plane” to Angle component (white group).

  2. Disabled the purple group that was culling grid squares that intersected the boundary. Replaced by culling buildings that are less than ‘MinD’ slider (Minimum Distance, white group). As you can see, this leaves some squares without buildings but there are more buildings than before. (87 vs. 71)

urban design_2024Feb8c
urban design_2024Feb8c1805×889 163 KB

urban design_2024Feb8c.gh (38.1 KB)