Rhino 8 lines in blocks don't show in print when two clip. planes enabled

Rhino 8 WIP (8.0.22291.12305, 2022-10-18) Commercial

Lines/Curves (inside blocks) in a detail view in a wireframe display mode don’t show when printing PDF (Adobe PDF, Rhino PDF, PDF24, etc.) when two clipping planes are enabled. Hatches inside these blocks show fine. They work fine in Rhino 7. They work fine when one clipping plane is disabled.

EDIT: Even when only one clipping plane is enabled lines in some blocks still don’t show in PDF print. Will need to revert back to Rhino 7.