Radial Slices nesting

[ucbqpac]

I cannot figure out how to lay down these radial slices from the image below. I am tempted to do it manually in Rhino. Please help!!! Nothing works.
210818-vase yuni.gh (269.6 KB)

[ucbqpac]

[ucbqpac]

[ucbqpac]

Okay I will just do orient and move in grasshopper and then manually move this around after baking in rhino.

[inno]

you just need to flatten your geometries: there are 30 different branches, so OpenNest is executing the nesting of 1 single geometry for 30 times on 30 new sheets
by flattening the “Geo” input, OpenNest will execute the nesting of 30 geometries one time on one single sheet