QUAD REMESH - Snap/Pull Vertices to Guide Curves

I love QuadRemesh and in this case it is so close to doing what I need, but not quite…

I have an elliptical planar surface that I want to remesh with some cellular curves. I want the cellular curves to define parts of the final mesh that I can relax under a load in Kangaroo to create depressions.

QuadRemesh nearly does this perfectly but there are some areas where the vertices do not lie on the outer boundary and areas where the mesh faces seem to be overlapping or self intersecting…

Is there a setting for QuadRemesh that I can change to improve this? Or is it a tolerance issue? Or am I best just trying to pull vertices to curves in Kangaroo before any relaxation and load deformation?

QUAD_REMESH_PUZZLE.gh (16.3 KB)

QUAD_REMESH_PUZZLE Edited v0.gh (30.0 KB)
Remesh a joined Brep might be a better choice.

Ah that’s a great tip! It meshes the cells better for relaxation!