Hi…, how to push-pull the edges and corner to zero? I don’t get it. https://www.rhino3d.com/stories/modeling/pushpull.gif(image larger than 4 MB) Thanks Michael

hi Jakob, where is the mode Extend? Thanks Michael

Hi @Michael_Meyer Make sure that you have AutoCplane turned on when selecting our subobjects and set the mode to Extend :slight_smile: [image] HTH, Jakob

in the command line for push pull

Hi Jakob and Kyle, I’ve found it, the option Mode=Extrude doesn’t show up for some geometry, e.g. side 2 in my case. I hope this will not confuse more people. [flexiCAD_cube_PushPull_test] flexiCAD_cube_PushPull_test.3dm (174.4 KB) Thanks Michael

it’s context aware… it only shows up where it can actually do the action you requested. @Joshua_Kennedy please correct me if I’m talking crazy here…

The face should extend. I opened an issue here to fix it.

Q: How to push edges, and corner to zero?

Serengeti (Rhino WIP)

brian (Brian Gillespie) September 8, 2023, 6:45pm 8

RH-76849 is fixed in the latest WIP

Topic		Replies	Views
Extend solids in push-pull gone? Serengeti (Rhino WIP) windows	8	128	April 20, 2026
Test Push_Pull incorrect Rhino for Windows windows	2	308	December 9, 2023
Push pull for "edges" Rhino windows	5	242	June 24, 2024
Pushpull limitations? Rhino for Windows windows , rhino8 , pushpull	8	514	December 8, 2023
Extend part of edge Rhino windows , extend	5	65	April 16, 2026

Q: How to push edges, and corner to zero?

Related topics