Possible to remove the 0 from fractional imperial dimension reading?

[PeterB]

When placing a straight dimension on a small object under 1" in length, the fraction always shows a 0 followed by the fraction. For example, 0 1/2". Is it possible to have that “0” removed entirely? I played with the annotation settings but couldnt find a solution. My only current solution is to manually enter the reading.

[John_Brock]

You must be using the Foot-Inch Architectural style.
Change to the Inch Fractional style.

[PeterB]

That’s better but I’d still like feet show for anything above 12"…

[John_Brock]

Rhino V6 has a Zero suppression option for this.

[PeterB]

Nice. When will it be released?

[John_Brock]

You can download the WIP now.
Haven’t you been getting messages about the Serengeti category?

Welcome to Serengeti

Serengeti, named after the largest African Savanna, is where Rhino grows. We like to involve users in every phase of the Rhino development process. As with prior releases, we invite current users to try, test, and provide feedback on the next release while still in development. You can now participate in the development beyond the upcoming release. Since many development efforts span more than one release, we have set up the Serengeti Project to give users more direct influence on all future …

[PeterB]

Thanks John, but I’m too busy right now to set this up. I’ll wait for the full release.