Another offset-question: I have a tree of multiple offsetted polygons (file attached). The offsets are irregular. That means there are sides that are offsetted by a different distance. E.g. “0” → No offset. Therefore I´m not using normal offset-components such as Clipper. As you can see in the image…

Hello, I went in a completely different direction, it works for these cases but may not for others. The idea is to create planes from the initial polyline (one per segment), offset these planes accordingly (1 or 0), split the surface and retrieve the only piece of surface that is “inside” all the …

Overlapping Offsets

Grasshopper

magicteddy April 1, 2023, 10:41am 19

Nice solution !

The offsets have been reworked on Rhino 8. Haven’t tested on my side, but it should remove the necessity for Clipper.

1 Like