New Feature Sr8: Gumball: treat edges like curves

Hi Brian
I don’t understand the new feature of Sr8 : Gumball treat edges like curves .
I do not see anything new.
Can you make an example?
Ciao Vittorio

Hi Vittorio - previously, Gumball, set to align by object, and applied to a sub-selected edge, ignored the fact that it was a curve and did not align itself correctly- this was most obvious on a linear edge at some odd angle to the Cplane- the gumball will now line itself up to the linear edge as if it were just a line.


I can add that this was already in SR7 - I used it extensively - but sometimes the “what’s new” items don’t get added to the web page until later…