Multipipe gives twisted topology v0.gh (25.3 KB)
Hi, @DanielPiker
I found Multipipe gives twisted flow of topology.
It is unnoticeable when the geometry is round, but very obtrusive if I crease the MP result.
Is it possible to correct the topology, so it is not skewed?
Hi @Quan_Li
Here’s a way to avoid this issue:
MultiPipe does take the minimum twist connection for each strut, but the issue here is that the input curves were split at the midpoints, so creating 2 struts along each of the long edges.
Thank you very much! This solution is perfect!
