Moving the start of a point series on a curve

Hello,

I was wondering how I can map a set of points a curve so that I can adjust where the start of the points on that curve begin. Below is a photo of what I mean. Say I want to change ‘point 0’ and move it one location to the right where ‘point 1’ is. On one curve.

I figure a line between curve each curve and being able to adjust the start and finish, should give me control as to the angle of the line along the surface?

2

Seam?

1 Like

… or Shift List

1 Like

I kneeeew it was something simple! I just couldn’t think of the command to drop in. Appreciate it @Joseph_Oster and @Jakinta

-Michael