Hi Im trying to model a device in grasshopper and Im running in to issues. Here is a picture of the project:
The piece in the middle rotates and twists the strings. I’m attaching the script I have so far:
6.gh (54.3 KB)
So far Ive gotten straight lines to connect from the outside to the middle, but I can’t figure out how to make them into curves, or how to get them to twist around the center as opposed to overlapping each other.
(Note: I have the script hooked up to the physical model so that the digital one responds to the output from the motor.)
Any help at all would be greatly appreciated!!! Thanks