When I create a curve and then translate it in Y, I am able to loft the original and translated curves without a problem. However, when I create a curve and rotate it around one of its edges, I don’t seem to be able to create a loft between the original and rotated curve. I can do this in Rhino but when I do it in Grasshopper, I just end up with the 2 curves.
I feel like I am doing something stupid but I can’t figure out what. Thanks for any help!
Thanks, Joseph!
I was thrown because the loft of the translated curves didn’t need to be flattened and they seem equivalent? But my grasp of data trees is pretty tenuous.
Thanks so much for that video link - it sounds very helpful. I’ve been subscribing to every Grasshopper channel I can find but hadn’t seen Andrew’s yet.