HI Expert
I hope you are doing well today.
i need to draw line and to make boundary between posts.
in given files there are points at same numbers but needed to join and create safety screens.
i have tried and spent time but to no avail i m here looking for your help.
Thanks very much for time and helping.
its ok just those parts are blanks.
i have made it boundary and extrude it by 4mm so that parts not changing.
could you please figure out the issue.
the root of the problem is in the orientation of some posts:
your posts are oriented by planes constructed over squared surfaces referenced in Rhino,
so I guess you will have to sort out the perfect orientation of those surfaces in Rhino?
True but the task was of a different approach. that Inno sorted.
earlier it were lines directly attached to post but this time I have made offsets to create the screens so thats why I have to do that. New thread.
But thanks all for the help.
Thanks for advice and i will remember it. unfortunately it was a rush work to complete the task so i did not realize but good to understand now.
Have a good day ahead.