Just upgraded my Rhino to Rhino 7 from 6 and encountered the following error:
The list of components causing problems:
line to beam
mesh to shell
dissassemble element
material
orientate elem
Loads
Cross Section
Modify Cross Section
Material Properties
Analyzenonlin WIP
OptiCroSec
BESOBeam
BESOShell
OptiReinf
Utililization
ShellLineResults
ShellVecResults
S-Forces
Stitches
components still work fine in rhino 6, both are on the 201012 build.
Hi @christopher.ho,
did you make sure to install the Rhino7 version of Karamba. There is a separate installation.
Hi @matttam,
I have both rhino 6 and 7 version installed.
I tried with rhino 6 version uninstalled.
Both versions removed and a clean v7 install and still no luck.
Hi Christopher, that is strange. Which version of Karamba? The official release is from 12 October 2020.
I’ve managed to find the problem, a custom plugin that I built references the rhino6 KarambaGH, disabling the plugin allowed karamba to load it’s components without problems.
I’ll rebuild the code with the new karambaGH for Rhino7.
