Join/merge edges?

I have an edge of a trimmed surface that I know is a single radius, but is split into two edges.

Is there a command to make a single edge out of them?

If I try the “join edge” command, I get “can’t find overlapping intervals”, but there’s only two edges to highlight on the side of this surface, so I don’t know why it would say that.

Hello - MergeEdge is the chap. Also `MergeAllEdges’


And I wrote it in the title of this thread. :rofl:

I don’t understand why it didn’t work the first time I , but thank you, it works now! :slight_smile: