How can I make the facade's edges clearer?

[Rain2 (Rain)]

фасад.3dm (2.6 MB)
1.gh (11.4 KB)

Hello! in this picture, you can see a facade that has clear toplines, but I can only make them smooth and I can’t figure out what needs to be added to the algorithm to make them clear. I started learning grasshooper not so long ago… I would be grateful if someone could tell me.

[Quan_Li]

How can I do catenary curves between consecutively points?

My suggestion. First, you need to convert it into a quad mesh using QuadRemesh. Then, make it into SubD objects, keeping the edge creased is a must. Third, build your final product using SubD.(or just change into a Brep and continue from there?) Finally, change the Closed SubD objects into a Brep(Shown in the picture, just 3 steps). So here, how to change it into a SubD is important. The first and second steps can be done at the same time using QuadRemesh. Just higher the edge length maybe …

[Quan_Li]

1 Edited v0.gh (42.8 KB)

[Rain2 (Rain)]

God, thank you so much! my question is, what kind of curves did you add here to get this result?

And what’s in this block? Qsettings?

[laurent_delrieu]

You could also use other ways of smoothing the interior
this one need Nautilus

1 Edited v0 LD.gh (24.8 KB)

Or surely inflate Mesh could work

Geometry/mesh into one continuous surface to populate bubbled hexagons along the surface

[image] inflated_hex.gh (155.3 KB) If you are using the latest Rhino8 WIP you can try a brand new feature. First it improves the regularity of your mesh to give more even sizes, and all pentagons/hexagons/heptagons, then in this last release there’s a new component ‘MorphToMesh’ which lets you define any geometry for each polygon type, and maps this to each corresponding cell in the mesh. So here it does an inflation simulation for each of the 3 reference polygons, then maps these to the who…