Grasshopper Display Error when using Silvereye and Karamba on Rhino 7

Grasshopper
1

I am getting the following display error message when I try to open Silvereye in Grasshopper. I am using Rhino 7 so I am not sure if this is the issue. I reinstalled Rhino 6 and it works in this without any problems, however I would really quite like to have it working in Rhino 7. I get the same error when using Karamba3D’s Material Properties.

Error Message
Error Message_02

Thanks!

1 Like
2

same problem…

3

Same problem here, did you solve this?

4

Still no answer… I just went back to rhino 6 it still works there