GH - Remote Control Panel (RPC) hung



Has anyone else experienced that the RPC suddenly stops receiving mouse clicks? It didn’t recover from it’s zombie state even after reopening Rhino + GH + the definition.

I had to open the GH Def with Rhino 6, click and drag on the RPC sliders (OK) and save the GH, in order to get life back into the RPC in R5.

Does anyone have any idea what could have caused it, or at least, how to “unlock” that zombie state? (I know the RPC stopped responding when I clicked on a slider and slipped a few pixels with the mouse at the same time).

OK, this was a bit “deep” to ponder about, but anyway.

// Rolf