It is a bit annoying when I do lock GH and try to place a new component and then connect new wires but after each step, Revit is running for few minutes…
Does lock should not stop this behaviour ? is there any workaround…
I am happy to do some session to show this…if needed
ok testing now and on Rhino nodes it works perfectly.
However, on our nodes, we still have the same issue.
Do we need to add any part of the code?
ok we found what cause this issue… because we have our SAM element with all Revit parameter GH is saving them all and it takes time to internalise them to JSON, solution to turn off AutoSave…
so issue solved
