From trimmed surface to untrimmed surface

Grasshopper
13

Following this post,

I didn’t find my answer yet. But how to transform a trimmed surface to an untrimmed surface. (no holes in it)

I have a complex trimmed surface that I further need to operate on.

image
image1332×1049 64.3 KB

I tried :

  • Rebuild surface. Still end up with trimmed srf
  • Quad remesh then mesh to surface? dead end? complex
  • Shrink trimmed srf (pufferfish component) not working.

The only option left I see is to rebuild that surface extraction its edges (that are shattered…), and some isocurve to further use network surface.

Before I go for this, is there anything I could do ?

Thanks :slight_smile:

TrimmedTOuntrimmedSRF_cc1.gh (182.8 KB)

CC