Filleting Troubles

[madmax95]

Hi Guys,

I am pulling my hair out trying to create a simple cube with R13 fillets on all of the edges. Regardless of the cube size, I would only like the fillets to travel 4mm into the faces of the cube on both sides. Is there a way to constrain the fillet tool to apply a 13mm fillet but only travel 4mm from the edge?

Thanks in advance!

[Stratosfear]

Give the Split edge command a try, to set the 4 mm stop point.

[Stratosfear]

It works as long as you set handles to zero at the split point.

[madmax95]

Thanks so much!