Extrude point to line

@pascal In another thread you said “in V6, points can be extruded into lines”

What command is used to extrude a point to a line in V6. I didn’t find an Extrudexxx command which does this in the current WIP.

Hi David - sorry, I was not clear - it’s the gumball-extrude - @Modeler3D had posted an image that looked to me like it was showing this in the WIP.

-Pascal

I was hoping for a command - ExtrudePt.

1 Like

+1 on the ExtrudePt command. We have ExtrudeCrv and ExtrudeSrf…

At one time, several years ago in a development cycle, we were extruding Points into Curves. It’s been too long to remember why we decided against it for the released version.

It may have been something similar to ignoring the 6 points that should be created when a Box with a tangent Sphere inside are Intersected.

Added: https://mcneel.myjetbrains.com/youtrack/issue/RH-53828

1 Like