I have a surface resulted from a loft curves. I have to extend the surface, extending the faces until it will close to one end. Any suggestions are apreciated . Thank you!extend loft.gh (7.2 KB)
Is Extrude to point what you are looking for?
faces must be continous, If i extrude to a point the planarity of the faces will brake. The faces dont intersect into a point
Then i misunderstood you.
I used extend face (downloaded from forumum discutions) but the face extension doesnt considers the intersection between adiacent faces.
So in a sense, you got a pyramid, that is untrimmed?
And you want it to be trimmed?