Disappearing Sweep1 options

The following occurs in V5, V6.14, and the WIP.

  1. Run -Sweep1 (macro), inputting any number of curves for the cross sections.

  2. Click SimpleSweep twice to toggle its setting to Yes then No.
    Result: The Style option is missing.

  3. Click SimpleSweep twice to toggle its setting to Yes then No.
    Result: The Simplify option is also missing.

  4. Click SimpleSweep twice to toggle its setting to Yes then No.
    (There is no noticeable difference yet, but this additional toggle must occur for the RefitTolerance value to be missing as stated below.)

  5. Cancel the command or create the sweep.

  6. Run -Sweep1 again. Input the curves.
    Result: The RefitTolerance value is now missing. Style and Simplify are still missing.

  7. Cancel the command.

  8. Run Sweep1 (GUI).
    Result: None of the 3 lowest radio buttons are checked, and the Unset value appears in the dialog box “Refit cross sections within”.