Dimension Tolerances

I would like to put a dimension like this: 6 5/16" ± .005. Is there anyway to mix and match fractions and decimals this way?

Hi Markcam- you can apply tolerances in the dimension style - in DocumentProperties > Annotation > Dimensions, or by selecting an existing dimension and going through its Properties, but as far as I can see the format follows the dimension format, it does not mix and match.


Ok thanks Pascal. That is how I have been doing it and didn’t know if I was missing a feature.

I think as a general rule, mixing of formats like that is considered a pretty bad practice in dimensioning.