DIA-GRID shell design - help!

Grasshopper Karamba3D
1

hi, i am an architect finishing a small project and i just started learning karamba, i would like help on setting up a file with analysis & support optimization for a dia-grid shell desgin
i modelled the beam lines and started to setup karamba for columns (i have imagined 4 V-columns) but don’t know how to incorporate the loads/supports into karamba, help me :slightly_smiling_face:

it should look like this at the end

C5-1
C5-11269×787 35 KB

now i have this
str-model
str-model1324×755 170 KB

2

Hi @iammmkaram, please see the examples on our website on how to setup your karamba analysis.

Supports are defined as points in your geometry and loads can be applied as gravity, line loads, point loads or mesh loads using the Loads component.