Curve, Free-Form, Interpolate Points

Rhino
1

Afternoon,

Can you advise please?

I’m an absolute novice with Rhino. I use Curve, Free-Form, Interpolate Points to trace lines on a drawing. I drop points along the lines. I’ve accidently clicked a mode where the pointer is just selecting, north, south, east & west rather than directly over the lines. How to I revert back to normal pre-set please?

Thank you.

Steven

2

Looks like you activated Ortho mode. You can de-activate (toggle) this setting by clicking in the status bar pane at the bottom, or with F8 in Windows Rhino. Holding down the Shift key will temporarily toggle the setting while the key is held down.