Control of annotation location

I love Rhino3d. I’ve used it for several years now and just about every day. Sometimes, it drives me up the wall. Usually this happens when it changes the location of an annotation or won’t let me put the annotation where I want. Here’s an example. In the first picture the angle dimension of 90 degrees between the post and the reference line is correct and what I want.

BUT. Then I extend the reference line and here’s what happens.

and the only way I have found to control the angle measurement is to delete it and re-do it which seems dumb. Why does it change anyway? Grrr. I haven’t bothered to post the whole file or my system things because it is something in Rhino. When it comes time to do a Rhino 10, I hope we get some say in fixing annotations to have more control.

Hi Joe,

When you placed the angle dimension, I am assuming you have Record History enabled? With Record History on, the dimension stays tied to that line / point. When you extended the reference line to the left, the dimension is updating to stay at that position along the line.

To avoid this:

  1. Turn off Record History before adding dimensions. You can toggle it with the Record History button on the status bar.
  2. Remove history from existing dimensions. Run HistoryPurge and select the dimension. It will stay put when you edit the line afterward.

If that doesn’t match what you’re seeing, please post the file and we’ll take a closer look.